Quantitative Measurement of Myocardial Perfusion by Cardiac CT in Patients

Reliability of the hypothesis:

On phantom studies simulating myocardial perfusion measurements and in animal studies we could confirm that using advanced CT technology (as e.g. "iCT 256 Brilliance") it is possible to measure myocardial perfusion in absolute values - in ml/100g/min. These myocardial perfusion measurements did not differ from those received by EBCT (Electron Beam Computed Tomography). Based on these experimental results and based on the quantitative measurements of myocardial perfusion in 1500 patients studied by EBCT at the Medical University of Graz the hypothesis may be done that using the above mentioned iCT 256 technology, it should be possible to measure myocardial perfusion quantitatively in a daily clinical practice.

Ethical aspects:

The study will be performed according to the international regulations (ISO 14144:212-01) and in agreement with the "Declaration of Helsinki". After oral and written explanation of the planned study and by signing the study agreement by patient and by responsible physician, patients participation is voluntary. The patients participating can leave the study any time without negative sequels for him or her. There is no financial restitution for the patients.

Patients will be informed about (very rare) possible allergoid-toxic reactions during and after intravenous contrast agent application. For possible emergency well trained medical staff and equipment is present. About renal insufficiency: renal failure (creatinin clearance <60ml/min [GFR (Glomerulo Filtration Rate)will be calculated according the Cockroft-Gault-Formula, GFR {ml/min}=((40-age)*weight{kg}*0,85{only for women}]/serum creatinin [mg/dl]*72) above.

The applied X-ray dose (CT) may and will be reduced by:

reduction of KV (kilovoltage) from 120 to 100 or 80 in dependance of patients weight, reduction of MA (milliamper)by using iterative image reconstruction allgorithm (iDOSE). These technical approaches represent the best possibility to reduce X-ray dose for the patient. As the coronary heart disease with stenotic lesions above 50% is a disease mainly of an elderly men (in female mostly after menopause and in male after 50 years of age) the risk for X-Ray dose related genetic defects is very low. The expected applied X-Ray doses by the above mentioned approach will be very low and therefore the risk of X-Ray induced malignancy may be regarded as very low too.

Design:

Prospective study to measure quantitatively myocardial perfusion in the above mentioned three groups of patients with simultaneous control and registration of all essential, physiological determinants of myocardial perfusion immediately before the CT study. The CT myocardial perfusion measurements will be performed directly after the indication for intervention or surgery and on the last day before discharge from hospital.

All the collected data (determinants) including the CT-studies will be anonymised and archived on a local server. These anonymised data may be approached only by members of Graz University of Technology, Institute of Health Care Engineering who will perform the evaluation of the myocardial perfusion measurements and the statistical analysis independently of the CT-studies performing physicians.

Practical procedure:

1. In supine position on CT table the blood pressure and the heart rate will be measured and registered.

2. In all patients a standard native cardiac CT for evaluation of coronary calcification by Agatston score will be performed.

3. In all patients myocardial perfusion will be measured in inspiration and contrast agent application where by the amount of contrast agent and the applied dose is related to patient weights as shown below:

Patient Perfusion 210mg Iodine/ml Expected dose weight [kg] / [kV/mAs] / [ml] / per shoot [mSv](milli Sievert)

<60 80/80 40 0.21/ 60-70 80/100 50 0.25/ 70-90 80/120 60 0.30/ 90-100 100/90 70 0.40/ >100 100/100 80 0.43

4. Standard cardiac CT will be performed to evaluate coronary arteries and left ventricular volumes.

5. In supine position on CT table the blood pressure and the heart rate will be measured and registered.

Quantitative evaluation:

The calculation of the myocardial perfusion succeeds in all slices with visible left ventricular myocardium using a modification of the formula described by K.Miles and model based approaches.

The calculation of the left ventricular volumes succeeds by use of the vendors software.

Statistic:

All personal and measured data will be anonymised, tested, analysed and evaluated in Graz University of Technology.

The numerical values will be expressed as mean +/- SD (min, max, 95% CI). p-values of 0.05 will be regarded statistically significant. Paired test and or Wilcoxon signed-rank tests will be used. X² analyses will be used to compare categoric variables. Additionally correlation analyses (Pearson, Spearman) will be performed and method of classification (pre- vs. postoperative) will be applied. All calculation will be done by SPSS 21.0 (SPSS, Chicago, Il, USA) or by Matlab statistic toolbox or R.

The neccessary number of studied patients is based on the results of 64 patients studied before and after aortic valve replacement in whom the myocardial perfusion was measured before and four months after surgery.

Pre-operative: Mean=74 (SD=21) ml/100g/min Post 4 Months: Mean=78 (SD=20) ml/100g/min. Difference= +4ml/100g/min. With 0.5 supposed correlation of the measured values the standard deviation of the differences may be estimated as 20ml/100g/min.

By alpha=0.05, 1-beta=0.80, n=209 patients is needed.

In addition to the pre- and post surgery evaluation, statistical models explaining the influence of collected data on the quantitaitve myocardial perfusion will be computed.

As a drop-out quote of 10% may be expected it is neccessary to study in each group of patients 230 patients. This means total 690 patients.

All data will be registered in database and tested for plausibility.