11 結果
Chitosan-gelatin (Cs-Gel) scaffolds are modified with poly (DL-lactic acid) (PDLLA) dichloromethane solution of different concentrations (0.1, 0.5, and 1.0%) and immersed in water after the evaporation of the solvent. The swollen scaffolds are freeze dried. The concentration of PDLLA has significant
OBJECTIVE
Droplet size in microfluidic devices is affected by wettability of the microfluidic channels. Three-dimensional countercurrent flow focusing using assemblies of chemically inert glass capillaries is expected to minimize wetting of the channel walls by the organic
Porous PLA structure has been widely used in cell transplantation, drug carrier and wound dressing. The porous structure can be controlled depending on the choice of the polymer, solvent, nonsolvent and preparation parameters. In this study, the porous PLA matrix membranes were prepared by adding
Monodisperse poly(DL-lactic acid) (PLA) particles of diameters between 11 and 121 μm were fabricated in flow focusing glass microcapillary devices by evaporation of dichloromethane (DCM) from emulsion droplets at room temperature. The dispersed phase was 5% (w/w) PLA in DCM containing 0.1-2 mM Nile
Patchy and patchy Janus particles composed of poly(dl-lactic acid) (PLA) and polycaprolactone (PCL) regions were produced with a controlled size, patchiness, composition, and shape anisotropy by microfluidic emulsification and solvent evaporation. Isotropic particles composed of PCL patches embedded
The preparative method of a block copolymer of poly(dl-lactic acid) (PLA) and methoxypolyethylene glycol amine (MeO-PEG(N)), named PLA-(MeO-PEG), was refined. The degree of introduction of MeO-PEG(N) into PLA increased up to 55% (mol/mol) using a dichloromethane/methanol mixture (1:1, v/v) as a
Biodegradable poly(DL-lactic acid) (PLA) and poly(lactic-co-glycolic acid) (PLGA) microparticles with tunable size, shape, internal structure and surface morphology were produced by counter-current flow focusing in axisymmetric (3D) glass capillary devices. The dispersed phase was composed of 0.5-2
We have studied the effect of the solvent system during preparation on the morphology, encapsulation efficiency, and release characteristics of enoxacin microparticles intended for localized delivery to the bone for the treatment of bone infections. Microparticles of enoxacin were formulated using
Nanocomposite particles are suitable for inhalation; however, their systemic migration has not been confirmed. The aim of this study was to compare drug concentrations in lungs and blood after inhalation of nanocomposite particles.Rifampicin (RFP) was used Camptothecin (CPT)-loaded nanoparticles were prepared using poly(dl-lactic acid) (PLA) and poly(ethylene glycol)-block-poly(propylene glycol)-block-poly(ethylene glycol) copolymer (PEG-PPG-PEG), and examined for particle characteristics, in vitro release, pharmacokinetics and efficacy. The
The purpose of this study was to fine-tune the mechanical properties of high molecular-weight poly-L-lactic acid (PLLA), especially to increase its toughness without sacrificing too much of its original strength. Besides of its long degradation time, PLLA is usually hard and brittle, which hinders